Greg,
I'll trust your research. However, MOM still finds a way around/through
its' chemistry!
But, I still like 'Good Stuff' a lot!
Best,
Duncan
On 07/21/2010 21:08, Greg Sevart wrote:
According to Dow Chemical, it's closed cell. If it were open cell, then it'd
probably fail pretty quickly. A closed cell foam should resist water pretty
decently.
It's unlikely that anything will be a permanent seal...
-----Original Message-----
From: [email protected] [mailto:hardware-
[email protected]] On Behalf Of [email protected]
Sent: Wednesday, July 21, 2010 7:38 PM
To: [email protected]
Subject: Re: [H] Insane method for protecting an ethernet join in a hole
ofwater
I had mentioned great stuff but someone aserted it was porous. I had
suggested a piece of pvc and using that at both ends
Sent via BlackBerry
-----Original Message-----
From: "Greg Sevart"<[email protected]>
Sender: [email protected]
Date: Wed, 21 Jul 2010 19:22:49
To:<[email protected]>
Reply-To: [email protected]
Subject: Re: [H] Insane method for protecting an ethernet join in a hole of
water
Interesting idea, but I'd confirm that the Crisco is really non-conductive.
Being essentially a fat, it would also decompose over time.
You could also consider trying a closed-cell expanding foam (ie: Great Stuff)
or silicone...
