Odds are any speakers for home/pc use are either 4 or 8ohm with most being 8, so not
likely to be an issue. When in doubt you can use a DMM on the speakers to read the
resistance. Biggest drawback of loading 8ohm speakers on 4ohm system would be 1/2
power output.
On 10/10/2010 6:37 PM, Anthony Q. Martin wrote:
Nope. I have no info on any of that. If it doesn't work I won't be out too
much as
this is either old or cheap stuff. I'm just trying to get some extra mileage
out of
this old gear.
On 10/10/2010 9:10 PM, Scoobydo wrote:
Are you sure of the ohms and matching speaker sensitivity? There may be other
considerations before I'd rush over to Radio Shack and start chopping wires.
IMHO,
not a good idea to mix speakers unless you're prepared for a negative outcome.
Good
luck!
