Al Johnson wrote: > So how easy is it to open and close this can without breaking anything?
Opening the main can is fairly easy. It's designed to allow this to be done. You need a small flat screwdriver (~2mm blade) and then carefully lift the shield on or near the corners opposite the BT module, in an area where you're not touching any electronic components. If you end up pushing against a small component, you'll shear it off the board, possibly causing mechanical damage to component and board, so it's better to resist the temptation of going for some extra lever effect. Repeat this along that edge and the sides until the shield moves freely. You can then rotate it on its back. The fun part is soldering things inside the can :-) But I assume you're already familiar with soldering SMT. - Werner _______________________________________________ hardware mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/hardware
