Hi,
Here is my attempt http://anyotherkey.googlepages.com/c
AFAIK I made a few mistakes:
1 I could have used a smaller sized 100uF cap
2 I could have used thinner wire, I picked up the wrong spool and didn't
realise
3 I shouldn't have tried to open a solder bridge on a 0402 component with a
relatively large iron.
I'm looking into the low volume of my voice on calls, I've only read up briefly
on what could be the cause. I can't be certain it wasn't always so low! I am
looking through the posts to figure this out from other peoples experiences.
_______________________________________________
hardware mailing list
[email protected]
http://lists.openmoko.org/mailman/listinfo/hardware
