Hi, I just ran the tests again, using make -i check. All tests passed except the istore tests, for which the screen output is shown in an email below. I checked this by grepping for "FAIL", which only appeared in the istore tests.
I am trying to build HDF51.8.5 on a RHEL4 Linux Cluster. I did not set any compiler flags, so it is probably using whatever is the default. I know that gcc and g77/gfortran are available on this cluster. There may be others, but I think those are usually chosen by default anyway by most makefiles. Jonathan On Jul 25, 2010, at 9:47 PM, Elena Pourmal wrote: > Jonathan, > > Please provide the version of HDF5 you are trying to build along with the > versions of OS and compilers used. > > Please also run make -i check to see if any other tests pass (or fail). > > Thank you! > > Elena > On Jul 25, 2010, at 11:22 AM, Jonathan Tu wrote: > >> >> On Jul 24, 2010, at 8:59 PM, Jonathan Tu wrote: >> >>> Hi, >>> >>> I am fairly new to Linux and am having trouble installing hdf5. I am >>> trying to install locally, as I don't have admin privileges on this Linux >>> cluster. I have downloaded and unpacked the source code, and ran >>> ./configure --enable-production --enable-shared >>> --prefix=/home/jhtu/local --with-zlib=/home/jhtu/local >>> --with-szlib=/home/jhtu/local >>> >>> Then when I do make check, all the tests pass until >>> >>> ============================ >>> Testing istore >>> ============================ >>> istore Test Log >>> ============================ >>> Test sizes: SMALL MEDIUM LARGE >>> Testing istore create >>> PASSED >>> Testing istore extend: 10 >>> PASSED >>> Testing istore extend: 10x10 >>> PASSED >>> Testing istore extend: 10x10x10 >>> PASSED >>> Testing istore extend: 10000 >>> PASSED >>> Testing istore extend: 2500x10 >>> PASSED >>> Testing istore extend: 10x400x10 >>> PASSED >>> Testing istore sparse: 5 >>> PASSED >>> Testing istore sparse: 3x4 >>> PASSED >>> Testing istore sparse: 2x3x4 >>> PASSED >>> Testing istore sparse: 30 >>> PASSED >>> Testing istore sparse: 7x3 >>> PASSED >>> Testing istore sparse: 4x2x3 >>> PASSED >>> Testing istore sparse: 50x50x50 >>> PASSED >>> *FAILED* >>> Command terminated by signal 11 >>> >>> Does anyone know what is causing this, and if it is important? >>> >>> >>> >>> >>> Jonathan Tu >> >> I tried this again and got the same errors. I tried attach a copy of the >> screen output, but it was too large for the mailing list. Does anyone know >> if this is important? It seems like all the tests in this section passed >> before I got the *FAILED* result. But then it also hasn't done any of the >> tests that might come after this. >> >> >> >> Jonathan Tu >> >> >> _______________________________________________ >> Hdf-forum is for HDF software users discussion. >> [email protected] >> http://mail.hdfgroup.org/mailman/listinfo/hdf-forum_hdfgroup.org > > > _______________________________________________ > Hdf-forum is for HDF software users discussion. > [email protected] > http://mail.hdfgroup.org/mailman/listinfo/hdf-forum_hdfgroup.org _______________________________________________ Hdf-forum is for HDF software users discussion. [email protected] http://mail.hdfgroup.org/mailman/listinfo/hdf-forum_hdfgroup.org
