On Sa, 15 Feb, 2020 at 17:30, Felix Salfelder <[email protected]>
wrote:
On Sat, Feb 15, 2020 at 04:45:22PM +0100, Matthias Brennwald wrote:
On Sa, 15 Feb, 2020 at 15:57, Felix Salfelder <[email protected]
<mailto:[email protected]>> wrote:
> $ git clone
<<https://git.savannah.gnu.org/cgit/gnucap/gnucap-models.git>>
Cloning into 'gnucap-models'...
fatal: repository
'<https://git.savannah.gnu.org/cgit/gnucap/gnucap-models.git/>' not
found
yikes. it's "git" not "cgit"
$ git clone
<https://git.savannah.gnu.org/git/gnucap/gnucap-models.git>
Works, thanks!
I have already started playing around with your example, so here's a
first question regarding the input voltage. You first set up the input
voltage as "vin nin 0 sin f=1k amplitude=20 ac 1".
- As far as I can tell, this gives 1 kHz sine with an amplitudie of +/-
20 V. What ist the "ac 1" part good for?
- Later on, you apply different DC voltages to the input (".dc vin -24
24 4") --> does that delete the previous configuration of the input
voltage? Where / how would I find this information in the Wiki manual?
- Then you seem to apply an AC signal ranging from 1 Hz to 1 MHz to the
input (".ac 1 1e6 * 10") --> how does Gnucap know that this AC sweep
should be applied to the input? Where / how would I find this
information in the Wiki manual?
