> menuentry "Xen Linux 2.6.32.27" {
> insmod ntfs
> set root='(hd0,2)'
> loopback loop0 /ubuntu/disks/root.disk
> set root=(loop0)
> kernel (hd0,2)/boot/xen.gz
> module (hd0,2)/boot/vmlinuz-2.6.32.27 dummy=dummy
> root=/dev/sda2 loop=/ubuntu/disks/root.disk ro console=tty0
> module (hd0,2)/boot/initrd.img-2.6.32.27
> }
>
>
> Entry 2 which failed is
>
> menuentry "Xen Linux 2.6.32.27" {
> insmod multiboot2
> set root='(hd0,2)'
> set root=(loop0)
> kernel (hd0,2)/boot/xen.gz dummy=dummy
> module (hd0,2)/boot/vmlinuz-2.6.32.27 dummy=dummy
> root=/dev/sda2 loop=/ubuntu/disks/root.disk ro console=tty0
> module (hd0,2)/boot/initrd.img-2.6.32.27
> }
Compare these with the entry given in the instructions that you linked to:
menuentry "Xen 4 / Ubuntu 10.04 kernel 2.6.32.12" {
insmod ext2
set root='(hd1,5)'
multiboot (hd1,5)/boot/xen.gz dummy=dummy dom0_mem=1024M
module (hd1,5)/boot/vmlinuz-2.6.32.12 dummy=dummy nopat
root=/dev/sdb5 ro console=tty0
module (hd1,5)/boot/initrd.img-2.6.32.12
}
Notice there is no "kernel" command in grub2, you need to use "multiboot".
Also, since I assume your /boot/ is within your wubi root.disk rather
than in "(hd1,5)" you should remove (hd1,5) from your file paths to
end up with an entry like:
menuentry "Xen Linux 2.6.32.27" {
insmod ntfs
set root='(hd0,2)'
loopback loop0 /ubuntu/disks/root.disk
set root=(loop0)
multiboot /boot/xen.gz
module /boot/vmlinuz-2.6.32.27 dummy=dummy root=/dev/sda2
loop=/ubuntu/disks/root.disk ro console=tty0
module /boot/initrd.img-2.6.32.27
}
--
Jordan Uggla (Jordan_U on irc.freenode.net)
_______________________________________________
Help-grub mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/help-grub
