Hi!
On 2023-03-09 03:50, Kyle Andrews wrote:
One of the selling points in Guix marketing for me is that the system
configuration should be self contained within /etc/config.scm and
channels.scm. However, this appears to not be the case. There seems a
third element hidden away which prevents me from running:
```
guix system reconfigure /etc/config.scm
```
This command errors out:
```
failed to load '/etc/config.scm'
...
no code for module ...
```
At the moment since I am still very early in setting up my new
computer,
I have to type everything so I'm not going to go into more detail than
that. Suffice to say it doesn't see the modules I need from the extra
channel. It did see them during the installation otherwise my computer
would be in a far less usable state than it is.
`sudo guix system reconfigure` and any `guix package` command will (by
default) use the generation shown in `guix describe`. On first boot,
this generation _will_ be different from the one you had in the live
system. This is because the generation is saved at
~/.config/guix/current on every `guix pull` and that file will be gone
together with the live system.
You have two options:
1. Get the channels you want correctly set up in
~/.config/guix/channels.scm and run `guix pull` with your user in the
running system. IIRC this takes a while because it'll download the whole
Guix checkout again (the one used to install would have disappeared
along with the rest of the live system).
2. Run guix pull -C /run/current-system/channels.scm. This will pull the
exact generation used to build the system. This will also take time.
After either of these you should be able to `sudo guix system
reconfigure ...` and get your system running as the channels will be
available again to every guix subcommand.
Note that you could also copy /run/current-system/channels.scm to
~/.config/guix/channels.scm but you have to be careful remove the commit
lines, otherwise all your `guix pull`s will pull the exact same commits
and you'll stay on an outdated system.
Maybe it could be clarified in the manual that another `guix pull` is
needed after the first boot. Or maybe the installation could be
optimized so that the checkout is copied from the live system to the
installed system.
When I run the following command:
```
guix system describe
```
The addition channel gets listed. How can it be listed yet be unknown
to
the `guix system reconfigure` command?
Because it was indeed the channel and commit the system was built from.
It has nothing to do with your "current powers". That all depends on
what generation of Guix you're using AKA what comes up in `guix
describe`
I hope my explanation was helpful!
SeerLite
