ha, wrong forum On Thursday, May 1, 2014 3:53:48 PM UTC-7, Zak Kus wrote: > > I was just checking this out: http://www.simplify3d.com/ > > I like their vision. Looks like the software provides a lot more refined > and nuanced control over slicing than i've seen elsewhere (i particularly > dig their support controls). However at $140, its a little too expensive to > just get on a whim. Has anyone used this before? > > -Zak >
-- You received this message because you are subscribed to the Google Groups "hexayurt" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/hexayurt. For more options, visit https://groups.google.com/d/optout.
