Joe, I wanted to ask you a question about which type of IHC stainer you are using and which stainer do you think is the user friendly and efficient.
-----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Joe Nocito Sent: Friday, February 26, 2010 4:51 PM To: CHRISTIE GOWAN; [email protected] Subject: Re: [Histonet] Fire in the lab Once upon a time in a far away land, we used to boil our embedding molds in boiling soapy water, over an open Bunsen burner, followed by an alcohol rinse then air dry. One time the fire alarm was activated and we had to evacuate the hospital. We were out there quit awhile. When we received the all clear to go back into the hospital, I was the first one back in the lab and the fire department was there, looking into our pot that had boiled out and was smoking up the lab. This wasn't the cause of the first alarm, but it did set off the second. Joe ----- Original Message ----- From: "CHRISTIE GOWAN" <[email protected]> To: <[email protected]> Sent: Friday, February 26, 2010 8:20 AM Subject: [Histonet] Fire in the lab Dear Histonet Friends, I just wanted to share an incident we recently had with an old paraffin pot. One of my techs came in on Sunday to embed some tissues, went into the processor room and smelled something burning. He noticed our old paraffin pot had charred looking labels on the outside so he went over, opened the lid and poof!!! the pot went up in flames. The thermostat had gone haywire and heated the paraffin to flash point. Opening the lid gave it the oxygen it needed to ignite. He triggered the alarm, made the appropriate call and then put it out with an extinguisher. Of course it kept re-igniting because he could not get behind it to pull the plug. The fire dept finally was able to get it pulled out and unplugged. Needless to say the tech was shaken and the room was a mess. I applaud his courage and am not sure I would have done the same. There was enough xylene and alcohol on the 4 processors to cause quite an explosion but everything else was in a flammable cabinet. I was wondering if this type of thing had ever happened to anyone else?? Needless to say, we have de-comissioned all old paraffin pots and will order only those with over temp safety features. I guess I just wanted to remind everyone that fires can happen in the lab and do probably more often than we hear about. This was the first time for me and I have been in this business for over 20 years. Take care and be safe. Christie Gowan HT (ASCP) _______________________________________________ Histonet mailing list [email protected] http://lists.utsouthwestern.edu/mailman/listinfo/histonet _______________________________________________ Histonet mailing list [email protected] http://lists.utsouthwestern.edu/mailman/listinfo/histonet ------------------------------------------------------------------------------ CONFIDENTIALITY NOTICE: The information in this e-mail may be confidential and/or privileged. If you are not the intended recipient or an authorized representative of the intended recipient, you are hereby notified that any review, dissemination, or copying of this e-mail and its attachments, if any, or the information contained herein is prohibited. If you have received this e-mail in error, please immediately notify the sender by return e-mail and delete this e-mail from your computer system. Thank you. ============================================================================== _______________________________________________ Histonet mailing list [email protected] http://lists.utsouthwestern.edu/mailman/listinfo/histonet
