I have had half-success (that is, one out of two routers worked) installing hnet-full. 1) I have a Netgear WNDR3800 where the instructions I posted at https://gist.github.com/richb-hanover/ec88b851c4da074e48003e6fe9276901 seem to work fine.
2) I have had trouble with a mqmaker.com WiTi router. Steps 1-9 (above) work fine. I can configure the two radios and the WAN port to hnet, leaving the LAN port on 192.168.1.1, and the router works as expected. Both W24 and W5 give out DHCP addresses, and E0 acquires a DHCP address from the upstream (Ethernet) router. When I convert the lan port to hnet as described in Step 10, everything comes to tears. After the reboot, the LAN ports do not give DHCP addresses, and I cannot connect to either wireless interface... What other information could I provide? Would it help to have a copy of /etc for the afflicted router? I also have a serial interface, so could send along the boot logs... Many thanks, Rich _______________________________________________ homenet mailing list [email protected] https://www.ietf.org/mailman/listinfo/homenet
