CaNe, one possible cause is misidentification of interfaces. If the eth1 interface is (incorrectly) connected to the LAN segment including the routers, packet multiplication will occur. That is, every LAN packet appearing on eth0 will be re-sent via to the LAN eth1. Effectively, this subjects the LAN to a DoS attack.
HTH. Cheers, On Wed, May 28, 2008 at 5:23 PM, sub <[EMAIL PROTECTED]> wrote: > Sounds like an IP conflict. Check the IPs of your honeywall and both > of your routers and make sure they are all different. > > > On Wed, May 28, 2008 at 6:29 PM, CaNe <[EMAIL PROTECTED]> wrote: > > This is my first attempt at using a honeynet and have run into an issue > > that i do not understand nor can find anything remotely similar on the > > web. The issue that Im having is that when ever i boot the honey wall my > > entire network loses connectivity. Im using two wrt54g routers and a > > hub. > > Modem > > | > > Router > > | \ > > | \ > > | Honeywall --Hub-- Honeypots > > Router > > | > > Network > > > > I'm using Honeywall 1.4 > > If anyone has some incite to this issue the reply would be greatly > > appreciated. > > > > Thankyou > > > > _______________________________________________ > > Honeywall mailing list > > [email protected] > > https://public.honeynet.org/mailman/listinfo/honeywall > > > _______________________________________________ > Honeywall mailing list > [email protected] > https://public.honeynet.org/mailman/listinfo/honeywall > -- Bill McCarty, Ph.D. Professor of Computer Science Biola University
_______________________________________________ Honeywall mailing list [email protected] https://public.honeynet.org/mailman/listinfo/honeywall
