Hi Jesse,
I do have gcc installed. So, I tried this...
# g++
(says not found)
I put /opt/gcc/bin in the path
and g++ or gcc works fine...
so, I tried to run the ./configure again and I get a
message, C++ compiler cannot create executable (this
time, even configure wouldn't run which ran
successfully previously.)
I thought, ok, perhaps gcc not installed properly.
Went to another server and same thing (C++ compiler
cannot create executable.)
All I am trying to do is, run ./configure
then make
then make install
anything I should do specially for htdig?
Regards,
--- "J. op den Brouw" <[EMAIL PROTECTED]> wrote:
>
> Hmm, I have no problem with compiling and running
> 3.1.5 on
> a HP-UX 10.20 machine. Are you sure, you're
> compiling with
> the GNU C-compiler (gcc and g++)?
>
>
> On Thu, 15 Feb 2001, impu wrote:
>
> > Hi,
> > I am trying to install htdig-3.1.5 under HPUX
> > 10.20. Basically, untar to ./configure goes
> without
> > any headache (see attached config.log). Then when
> I
> > am asked to run make, I do and come across this
> > problem... (I'm copying and pasting this below)
>
>
> --jesse
>
--------------------------------------------------------------------
> J. op den Brouw Johanna
> Westerdijkplein 75
> Haagse Hogeschool
> 2521 EN DEN HAAG
> Faculty of Engeneering
> Netherlands
> Electrical Engeneering
> +31 70 4458936
> -------------------- [EMAIL PROTECTED]
> --------------------
>
> Linux - because reboots are for hardware changes
>
>
> _______________________________________________
> htdig-general mailing list
> <[EMAIL PROTECTED]>
> Information:
>
http://lists.sourceforge.net/lists/listinfo/htdig-general
> FAQ: http://htdig.sourceforge.net/FAQ.html
__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail - only $35
a year! http://personal.mail.yahoo.com/
_______________________________________________
htdig-general mailing list <[EMAIL PROTECTED]>
Information: http://lists.sourceforge.net/lists/listinfo/htdig-general
FAQ: http://htdig.sourceforge.net/FAQ.html
