According to Reich, Stefan:
> If I get the documentation right, I cannot use allow in Form, as this is
> only valid for config attributes known by htdig, but htdig knows nogthing
> about my_param.
htdig, htsearch et al. allow you to define any arbitrary attribute.
You're not limited to the set of attributes that the programs
use themselves. I think that point needs to be clarified in the
documentation.
> I cannot use select Lists, because there is no fixed list of values for
> my_param, right?
If there's no fixed list of values, then no, build_select_lists isn't of
much use to you. I just pointed it out as something than can be used in
conjunction with allow_in_form, in case it might be of use for you.
> Sorry if I missed the point.
No problem. I should have made myself clearer.
--
Gilles R. Detillieux E-mail: <[EMAIL PROTECTED]>
Spinal Cord Research Centre WWW: http://www.scrc.umanitoba.ca/~grdetil
Dept. Physiology, U. of Manitoba Phone: (204)789-3766
Winnipeg, MB R3E 3J7 (Canada) Fax: (204)789-3930
_______________________________________________
htdig-general mailing list <[EMAIL PROTECTED]>
To unsubscribe, send a message to <[EMAIL PROTECTED]> with a
subject of unsubscribe
FAQ: http://htdig.sourceforge.net/FAQ.html
