On 07/02/2013 06:35 AM, T. Modes wrote:
Am Montag, 1. Juli 2013 19:40:20 UTC+2 schrieb Jim Watters:
cpclean will not remove bad line control points.
This is intentional. Cpclean will currently only remove "normal" cp.
All line control points are ignored (also for calculation of errors/limits).
The background was, that line control points are often set manual to
correct perspective or to level a pano. In my experience they have often
a little higher error than normal cp. So I ignored them in cpclean.
But I'm open for improvement proposals.
Question: I don't know how cpclean works. Does it take into account the
existence of line CPs when evaluating a normal CP? Such as if I have a
vertical line with one of its CPs located close by a normal CP?
--
David W. Jones
[email protected]
wandering the landscape of god
http://dancingtreefrog.com
http://www.clanjones.org/david/
http://dancing-treefrog.deviantart.com/
http://www.cafepress.com/otherend/
--
A list of frequently asked questions is available at:
http://wiki.panotools.org/Hugin_FAQ
---
You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/hugin-ptx/51D3D7F6.8020502%40gmail.com.
For more options, visit https://groups.google.com/groups/opt_out.
