Yes, I selected only the neighbouring images. This is an example of adding 2 images to a 29 image panorama that had a "black hole" inside. These 2 added images were from a different photo sequence and they covered the black hole. Finding points for all images would take hours. Thanks for explaining how the selection works.
Maybe the points are not duplicated pixel to pixel, but most of these are in the same places. When deleting one point, there is usually another one below. Finding points only for selected images will prevent this. [image: hugin find controlpoints only for selected images.png] On Wednesday, September 11, 2019 at 12:39:56 AM UTC+2, Erik Krause wrote: > > Am 10.09.2019 um 03:16 schrieb Abrimaal: > > > I selected image 6 to find points between image 6 and ALL the rest > > 6+0, 6+1, 6+2, 6+3, 6+4, 6+5 but NOT between 1+2, 1+3... ... 4+5 > > If you have a panorama with aligned images and you add another image it > usually is sufficient to create control points between this image and > one or two other images. However, it is good practice to add all images > to a project, then specify which of those should be treated specially, > (f.e. by viewpoint correction), then press Align. > > > Duplicated control points are not a problem, they don't change geometry, > > but it takes a lot of time to calculate. > > PTGui doesn't create duplicate points, it always creates additional ones. > > -- > Erik Krause > http://www.erik-krause.de > -- A list of frequently asked questions is available at: http://wiki.panotools.org/Hugin_FAQ --- You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/hugin-ptx/359fe2fc-788a-4133-8181-149083c4be6b%40googlegroups.com.
