Hello, I'm using hugin 2019.0.0 to stitch a 15-image mosaic together. The subject is a flat wall composed of evenly sized and spaced blocks and covered in graffiti. I started with a 3-image stitch composed of the middle 3 images in the series and have been adding an image to either end in successive stages. I've successfully completed 4 such stages and reached a successful 9-image mosaic, but the 11-image stage has stumped me, specifically the optimization step.
Like all previous stages, I add control points using "cpfind --linearmatch --ransacmode hom -o %o %s" then remove any that are not located on the main plane of my subject (there are slight protusions in places). I then add a (horizontal) line set to 'mode=Line n' to each image at about the same place on the wall as all previous stages, and one vertical line near the left and right sides of the image. In the Optimizer tab, I begin each stage by marking only the X, Y, and Z parameters for the new images and running the optimizer. I then clear those marks and add marks to the r, p, and y parameters for only the two new images before optimizing again. Up to this stage a simple click of the 'Fit' button on the Move/Drag tab of the Fast Preview window and i'd be off to the Stitcher tab and success, but with 11 images the 'Camera translation' column in the Optimizer tab is showing "not active" for the two new images, when all previous stages this status was confined to the anchor image. If I accept the optimizer results and view the Fast Preview, the two new images are not at opposite ends of the mosaic, but overlie the central anchored image. Very strange. Can anyone here please offer advice on how my workflow might be at fault? Thanks. Terry -- A list of frequently asked questions is available at: http://wiki.panotools.org/Hugin_FAQ --- You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/hugin-ptx/29e67653-f1db-467c-9e35-7ef0f45d33f7o%40googlegroups.com.
