" you will need to use all of these, but not all at once - this can confuse the optimiser. "
I want to understand that detail. Photos tab: Optimize Geometric: the calculate button: Does it start from zero when you click it or does it start from wherever any previous optimize finished? Your statement, that I want to understand, implies that previous values of its outputs influence it. In other kinds of software, a typical optimizer can find a local optimum in the parameter space that might be much worse than the global optimum, so the starting point can make a big difference. I don't know whether that is what you mean by "confuse". I tried to find such an effect with a simple experiment and failed. But likely because the experiment was too simple (If what you meant was a local optimum problem, not all sets of images and control points would even have any local optima). On Sunday, December 26, 2021 at 7:20:48 PM UTC-5 [email protected] wrote: > On Sun, 26 Dec 2021, 23:57 Jon Schewe, wrote: > >> >> Is there a good reference for what the following terms mean to Hugin? >> Position >> View >> Translation >> Barrel >> > > Position is roll, pitch and yaw. > View is the horizontal lens angle of view. > Translation is xyz position of the camera. > Barrel is the radial barrel (or pincushion) distortion of the lens. > > For your document assembly project, you will need to use all of these, but > not all at once - this can confuse the optimiser. I suggest starting with > translation, then adding position, then view and finally add barrel. > > -- > Bruno > > >> -- A list of frequently asked questions is available at: http://wiki.panotools.org/Hugin_FAQ --- You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/hugin-ptx/915994e2-9a62-4cce-94a2-e6d569e861c8n%40googlegroups.com.
