On Sat, 8 Mar 2008 01:08:27 am Jean Delvare wrote: > > BTW, note that you should NOT access the nvidia I2C buses created by > the binary nvidia X11 driver while not under X.
OK, thanks. I did look for them outside of X, but they weren't there. > OK. Two more things you can try: > > * Get rid of the binary nvidia driver for a moment, and try the > nvidiafb driver. If it gets better, it suggests that the binary nvidia > driver is at fault. If you get the same noise, it has to be a hardware > issue. There are no nVidia I2C buses visible with the nvidiafb driver, i2cdetect reports only the SMBus. Here's a snippet from the X log, though: (II) Loading sub module "i2c" (II) LoadModule: "i2c"(II) Module already built-in (II) Loading sub module "ddc" (II) LoadModule: "ddc"(II) Module already built-in (II) NV(0): I2C bus "DDC" initialized. (II) NV(0): Probing for analog device on output A... (--) NV(0): ...found one (II) NV(0): Probing for analog device on output B... (--) NV(0): ...can't find one (II) NV(0): Probing for EDID on I2C bus A... (II) NV(0): I2C device "DDC:ddc2" registered at address 0xA0. (II) NV(0): I2C device "DDC:ddc2" removed. (II) NV(0): ... none found (II) NV(0): Probing for EDID on I2C bus B... (II) NV(0): I2C device "DDC:ddc2" registered at address 0xA0. (II) NV(0): I2C device "DDC:ddc2" removed. (II) NV(0): ... none found (--) NV(0): CRTC 0 appears to have a CRT attached (II) NV(0): Using CRT on CRTC 0 Address 0xA0? Should that be 0x50? > * Did you try another video cable? The I2C bus signal is carried over 2 > dedicated pins on the VGA connector (12 and 15), if your cable happens > to not have them wired properly for some reason, this could explain > your problem. OK, I'll have to ask around for one. Thanks for your help. Jeremy _______________________________________________ i2c mailing list [email protected] http://lists.lm-sensors.org/mailman/listinfo/i2c
