--- Jean Delvare <[EMAIL PROTECTED]> wrote:
> Which bus do you see the device on in i2cdetect? You said
> earlier that you were using the i2c-i801 driver, which is expected for
> an Intel motherboard. However you say that the PIC is connected to
> an SMSC chip, and not the Intel south bridge? Are you sure? If you are,
> what is the name of the SMSC chip in question?
Okay, i was wrong. The smsc47m192 _and_ the PIC is connected to the SMBus I801
(at a040). If i type "sensors", i get sensor data from 0x2d.
> Which i2c bus are you running your program on? The
> "SMBus I801" one?
I'm afraid so.
> Note that it is not entirely impossible that the block
> write support in the i2c-i801 driver is broken. This is a driver which is
> mostly used to access SPD EEPROMs and hardware monitoring chips, to which
> you never write blocks.
Okay... so i've no chance to send the PIC block data. :'-(
Thanks a lot! I give up. ;-)
Nick
__________________________________________________________
Gesendet von Yahoo! Mail.
Dem pfiffigeren Posteingang.
http://de.overview.mail.yahoo.com
_______________________________________________
i2c mailing list
[email protected]
http://lists.lm-sensors.org/mailman/listinfo/i2c
