Hi Linda, We have revised draft-hujun-idr-bgp-ipsec and, to the best of our understanding, we do not see any conflict with our draft being discussed in I2NSF. The IPsec attributes configured through BGP are only the peer’s tunnel address and local/remote subnet prefixes (that are used for the traffic selectors). The rest of the IPsec configuration (AH/ESP, cryptographic algorithms, keys, etc.) are obtained via a “color mapping”, which is something not covered by the draft since it assumes routers are somehow pre-provisioned with this information.
Thus, we do not see this draft is also facing the task of formalizing the complete configuration of an IPsec device. We appreciate any clarification in case we are wrong. Best regards, Fernando. El jue., 28 mar. 2019 a las 16:01, Linda Dunbar (<[email protected]>) escribió: > > > Just to reiterate the concerns and issues I raised during IDR Thurs > session discussion on using BGP signaling to achieve IPsec Tunnel > configuration (draft-hujun-idr-bgp-ipsec). > > Copy I2NSF WG because there is similar discussion for over a year. > > Copy IPsecme WG as the group has many experts on the IPsec configuration. > > > > 1. I2NSF WG has an on-going discussion on Controller facilitated > IPsec configuration which has been discussed for over a year. Even though > the I2NSF’s IPsec Configuration is between Controller and devices, whereas > the BGP signaling IPsec Configuration proposed by draft-hujun-idr-bgp-ipsec > is between peers, the configuration parameters to the devices are for the > same purpose, therefore, should be aligned to avoid future conflicts to the > industry. > > > > 2. When using IPsec Tunnel between two peers, usually they are > separated by untrusted domain. If Router “A” is allowed to gets the IPsec > tunnel configurations from peers across untrusted domain (instead of the > today’s practice of from administrators), then many issues come up, for > example: > > > > How can a router “A” trust the Traffic Selection policy from a remote peer > B? If the router “A” already has its Traffic Selection policy configured > for a specific IPsec tunnel, but different from the Traffic Selection > policy from remote peer B, which policy should Route A enforce for the > IPsec Tunnel? If the router “A” doesn’t have Traffic Selection policy > specified, there are two remote nodes B & C signaling the “A” with > different Traffic Selection policy, what should A do? > > > > 3. RFC5566 only specifies a simple indication of IPsec Encap, but > doesn’t do any of the IPsec configuration portion. > > > > > > As indicated by BESS WG chair, there are multiple drafts addressing IPsec > in BESS, IDR, and WGs in Security Area, involved Chairs and ADs may need to > agree where is the home for continuing the discussion to avoid future > conflicts. > > > > > > Cheers, > > Linda Dunbar > _______________________________________________ > IPsec mailing list > [email protected] > https://www.ietf.org/mailman/listinfo/ipsec > -- ---------------------------------------------------------------------------------------------------- Fernando Pereñíguez García, PhD Department of Sciences and Informatics University Defense Center, (CUD), Spanish Air Force Academy, MDE-UPCT C/ Coronel Lopez Peña, s/n, 30720, San Javier, Murcia - SPAIN Tel: +34 968 189 946 Fax: +34 968 189 970 ------------------------------------------------------------------------------------------------------
_______________________________________________ I2nsf mailing list [email protected] https://www.ietf.org/mailman/listinfo/i2nsf
