Hi, all, We recently upgraded ADABAS to 7.4.3 from 7.1.3 and have seen CPU usage go up by a factor of 3 to 4 in our primary LPAR on our busiest ADABAS servicing some really busy CICS regions and batch flows. Other LPARs are seeing it too, but not as badly.
We typically had CPU usages of about 10 to 11% for the week. Looking at the last two months with average runs of 7,000 minutes, the ADABAS region averaged a use of 750 CPU minutes. Now in one run over a few days, it was 36%. A 2,700 run minutes used just under 1,000 minutes of CPU time. As the batch jobs are running longer and online users report slower turnaround, I'm concerned. Has anyone else who is using ADABAS seen anything like this if they have done this upgrade? We are working with SAG, the vendor, and, as luck would have it, I have a great resource from my good friends at CA part time for a few weeks looking at our set up here from a performance point of view. This LAPR was "under control" until the upgrade went in. Now I may have to focus the CA resource's time here instead of some other places. Setup is z/OS 1.4, running a z900-1C5. Peter Duffy Consultant, Operations Support - Mainframe/Distributed/Network __________________________________________NISSAN NORTH AMERICA Information Systems Department Gardena, CA, USA 310-771-6472 ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
