AFAIK.. this is not possible. You can have the mainframe unicast to a router .. then run EIGRP in the rest of the network.
Or take the route of OSPF.. which should be a bit of a pain to setup.. but very good once it is set. -Rob. -----Original Message----- From: IBM Mainframe Discussion List [mailto:[EMAIL PROTECTED] On Behalf Of Philip Miscione Sent: Tuesday, July 19, 2005 11:44 AM To: [email protected] Subject: RiP/EIGRP mainframe migration Sensitivity: Private All We planning to change our network routing protocol from Rip to EIGRP. This will enable better management of network addressing and allow for faster convergence during network failures. Currently our mainframe is running form of Rip and learning routes from the network(OROUTED). We would like to have the mainframe use a default route or gateway instead of using the dynamic routing protocol from the network. We want to remove Rip and run EIGRP. Can anybody give me a heads up as to configuring the MF stack to support it Do I just need to code the gateway statment and not use the bsdroutingparms statment and do I still need to run OROUTED ? TIA Phil M ------------------------------------------------------------------------ - This electronic mail message contains information that (a) is or may be CONFIDENTIAL, PROPRIETARY IN NATURE, OR OTHERWISE PROTECTED BY LAW FROM DISCLOSURE, and (b) is intended only for the use of the addressee(s) named herein. If you are not an intended recipient, please send an email immediately to [EMAIL PROTECTED] and take the steps necessary to delete the message completely from your computer system. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html This e-mail transmission contains information that is confidential and may be privileged. It is intended only for the addressee(s) named above. If you receive this e-mail in error, please do not read, copy or disseminate it in any manner. If you are not the intended recipient, any disclosure, copying, distribution or use of the contents of this information is prohibited. Please reply to the message immediately by informing the sender that the message was misdirected. After replying, please erase it from your computer system. Your assistance in correcting this error is appreciated. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
