Dear all
I checked our system.Please see informations below
On the bad system
D PROG,EXIT,EX=SYS.IEFACTRT,DIAG
RESPONSE=BT06
CSV464I 08.54.50 PROG,EXIT DISPLAY 176
EXIT SYS.IEFACTRT
MODULE STATE EPADDR LOADPT LENGTH JOBNAME
IEFACTRT A 8A4D3000 00000000 00000000 *
DLCABT05 A 960C21C8 00000000 00000000 *
On the good system
D PROG,EXIT,EX=SYS.IEFACTRT,DIAG
RESPONSE=BR04
CSV464I 09.07.26 PROG,EXIT DISPLAY 030
EXIT SYS.IEFACTRT
MODULE STATE EPADDR LOADPT LENGTH JOBNAME
IEFACTRT A 898C0000 00000000 00000000 *
On the bad system
D PROG,LPA,MODNAME=IEFACTRT
RESPONSE=BT06
CSV550I 08.55.34 LPA DISPLAY 182
FLAGS MODULE ENTRY PT LOAD PT LENGTH DIAG
P IEFACTRT 8A4D3000 0A4D3000 00000808 16BF2180
On the good system
RESPONSE=BR04
CSV550I 09.09.04 LPA DISPLAY 048
FLAGS MODULE ENTRY PT LOAD PT LENGTH DIAG
P IEFACTRT 898C0000 098C0000 00000808 15FF3090
Comparing our SMFPRMxx,I found there is a statement '
SUBSYS(JES2,EXITS(IEFUSI))' in the SMFPRMxx on the bad system
But on the good system, there is not this statement.
What can I do in the next step? thanks a lot!
Best Regards,
Jason Cai
发件人： Greeley, Kevin
发送时间： 2010-06-28 21:58:50
收件人： IBM-MAIN
抄送：
主题： Re: There isn't RC of step in the joblog
Compare your SMFPRMxx PARMLIB members.
Check if IEFACTRT is specified in SUBSYS(JES2... in SMFPRMxx.
Kevin.
-----Original Message-----
.ua.edu/archives/ibm-main.html
