On Wed, 14 Jul 2010 08:17:30 -0700, Mark Yuhas <[email protected]> wrote:
>Yes, I am doing what is described in the exit sample. Further, I >strategically generated a S0C1 to view the contents of the XPL and the >area pointed to by X053JXWR. Everything looks fine. Basically, the >exit exits after this. > >As I stated in my one of my previous posts, this code has been working >on a 1.7 system for 3 years, a 1.4 system for 3 years. As a matter of >fact, this code has been running like this since 1988. The only changes >I have made is to accommodate the use of the XPL and the exit running in >the USER environment. > Mark, EXIT53 did not exit in z/OS 1.4 nor in 1988, so I don't see how you could have been running it since then. You didn't answer a question I asked from earlier. Is this failing in a test environment, or did you upgrade the production environment with no other changes from 1.7 other than a reassembly / relink of this EXIT53? Or did it only exist as EXIT03 in 1.7? If using it as EXIT53 is new, don't forget that exits running in the user environment must be loaded into common storage. Assuming you have both an EXIT03 and EXIT53 with similar code, you load it as follows: LOADMOD(MYEXIT03) STORAGE=PVT LOADMOD(MYEXIT53) STORAGE=CSA Since you can load new exits dynamically, maybe you should assemble / link the sample "as is" and see if it works in your environment. I'm pretty sure this is a "user error" of some sort. Regards, Mark -- Mark Zelden - Zelden Consulting Services - z/OS, OS/390 and MVS mailto:[email protected] Mark's MVS Utilities: http://home.flash.net/~mzelden/mvsutil.html Systems Programming expert at http://expertanswercenter.techtarget.com/ ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
