I was thinking.. Its not NCP (not loaded yet) so its not way you code the NCP yet; its important to match the following in the NCP with the number of the channel adapter you are using its also import to know if you are using the Phisycal number or logical number. the above is in the VTAM/NCP books ok lets say hcd compile good ... so the chipid is cool but the device not so cool. With all respect are you connected to the rigth CA bus/tag position... are you using the logical position as you map.. are you in the Extented frame position... this is stuff is in the phycal planning guide. That in the url i sent B4.. next the moss needs to have the CA adapter config (most important is too plug the address (are you using 00 as your ucb i think 00 is the defalut) if needed to change also the adapter must be active and if you are using EP the range the UCBs. ( check the chpid port at the CPU follow it) like they said gary away)))
like b4; i did 3 of them... pure bus and tag and ESCON converters.. you can call me no problem to talk 201 413 8952 anthony ----------------------------------------- The information contained in this electronic mail message, and any and all accompanying documents, constitutes confidential information. If you are not the intended recipient of this information, any disclosure, copying, distribution, or the taking of any action in reliance on it is strictly prohibited. If you received this information in error, please notify the sender immediately and destroy this communication. Messages sent via this medium may be subject to delays and/or unauthorized alteration. Neither The Bank of Tokyo-Mitsubishi, Ltd. nor any of its affiliates shall be held liable for the contents of this message. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
