On 4/3/2011 20:04, Knutson, Sam wrote:
We don't have either but you should check with HDS and all your hardware
vendors as part of your systems assurance.
We had to upgrade microcode levels on Brocade DCX and McData FICON directors to
support the 2817.
You need to check everything with the vendors.
Best Regards,
Sam Knutson, GEICO
System z Team Leader
mailto:[email protected]
(office) 301.986.3574
(cell) 301.996.1318
"Think big, act bold, start simple, grow fast..."
-----Original Message-----
From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of
HsuBright
Sent: Friday, April 01, 2011 12:00 PM
To: [email protected]
Subject: Any z196 running with HDS USP/USPV and/or STK VSM4/VSM5?
The shop has USP and VSM4/VSM5, and is going to install z196 very soon, just
want to make sure someone has gone through this.
thanks!
====================
This email/fax message is for the sole use of the intended
recipient(s) and may contain confidential and privileged information.
Any unauthorized review, use, disclosure or distribution of this
email/fax is prohibited. If you are not the intended recipient, please
destroy all paper and electronic copies of the original message.
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
Can only address your STK VSM5 question.
We were at NCS6.1.0 on a VSM5 FICON attached to the z196 8GB FICON. The
VSM5 came up ready to go no changes needed. Gone now...
Regards, Doug
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
