You can not use built-in address of IBM PCI 10/100 ETHERNET card in MP3000. If you do not specify locally administrated address, then following message appears during boot:
Unable to load using the individual node address stored on the NIC. A valid address must be provided by using the NODE parameter in PROTOCOL.INI Failure: Driver did not load, NDIS environment invalid. SYS1201: The device driver C:\IBMCOM\MACS\IBMFE.OS2 specified in the DEIVCE statement on line nnn of the CONFIG.SYS file was not installed. Line nnn is ignored Burnt-in address of tokenring cards can be found in C:\IBMCOM\LANTRAN.LOG. To find MAC address of ethernet-on-board, run MPTS, configure protocol IBM IEEE 802.2 and do not specify locally administrated address (neither in properties of adapter, or in properties of protocol IEEE 802.2 or NETBIOS). Then reboot and look into C:\IBMCOM\LANTRAN.LOG If you do not specify slot position of ethernet cards in MPTS, the cards are assigned from bottom to top. So the first ethernet adapter specified in MPTS is ethernet-on-board. Tomas On Wed, 15 Mar 2006 12:08:50 -0300, Bodra - Pessoal <[EMAIL PROTECTED]> wrote: > >How can I get burn in MAC ADDRESS of MP3000 Ethernet adapters? > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
