Hi Justin, It works. thanks a lot and thanks for your advice for the "FULL DUPLEX" to "DUPLEX PENDING" state,
tommy __________________ As it mentions in the ADR918I message explanation, for extent reason codes you have to look at the QFRVOLs extent reason codes in the Advanced Services manual. Your target appears to be a PPRC primary volume which cannot normally be eligible for a target Flashcopy relationship. Refer to the following FCTOPPRCprimary keyword explanation: http://publibz.boulder.ibm.com/cgi- bin/bookmgr_OS390/BOOKS/DGT2R241/3.6.4.28? SHELF=EZ2ZO10G&DT=20060126011812&CASE= Pretty sure that using this keyword will resolve you issue, but be AWARE your PPRC relationship will go from full duplex to duplex pending state. Again you can refer to the Advanced Services manual for more information on PPRC volume relationships. Also this DFSMSdss support was shipped in OA06196 and will be needed to specify the keyword, but addtionally some HW support is also required (refer to the ++HOLD information in the OA06196 apar). Justin *********************************************************** This message contains confidential information which is intended only for the person or entity to which it is addressed. If you are not the intended recipient, you should not read, disseminate, distribute or copy this e-mail. Any opinion contained in this message are those of the author and are not given or endorsed by BOCHK unless otherwise stated in this message and the authority of the author to so bind BOCHK is duly verified. We do not guarantee that this e-mail is virus-free or secure and are not liable in respect of any delay or omission in the transmission of this message. *********************************************************** ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
