Daniel Did you see my analysis of the IEA705I messages?
> IEA705I ERROR DURING GETMAIN SYS CODE = 878-10 QLUSER1S DDDE > IEA705I 00F90280 007C0C48 007C0C48 00001200 00D29240 >From what I find in the description of the message, 00D29240 appears to be the amount of storage requested - which looks suspicious. Perhaps another cause of the problem is that the program has managed to pick up incorrect data from somewhere when it imagined the data represented an amount of needed storage. Chris Mason ----- Original Message ----- From: "Daniel A. McLaughlin" <[EMAIL PROTECTED]> Newsgroups: bit.listserv.ibm-main To: <IBM-MAIN@BAMA.UA.EDU> Sent: Monday, 09 October, 2006 1:00 PM Subject: Re: help with 878-10 > Explanation: The error occurred when the system was trying to do one of > the following: > Satisfy a request made through the STORAGE macro > Process an RU or VRU form of the GETMAIN macro > Process an RU form of the FREEMAIN macro > A reason code in the SDWACRC field of the system diagnostic work area > (SDWA) explains the error: > Code Explanation > 04 > There is not enough virtual system queue area (SQA) storage available to > satisfy the request. > 08 > There is not enough virtual common service area (CSA) storage available to > satisfy the request. > 0C > There is not enough virtual local system queue area (LSQA) storage > available to satisfy the request. > 10 > There is not enough virtual private area storage available to satisfy the > request. This is due to one of the following: > A program is requesting virtual storage, but not subsequently freeing the > storage. > The region size specified is too small. > An installation exit is requesting virtual storage from a V=R region > before initialization of the region has completed. > > Programmer Response: A complete dump is necessary to diagnose this out of > storage condition. If no dump was produced, SLIPs should be set to obtain > a dump on problem recurrence. Further debugging information may be found > in Informational APAR II05506. An abend 80A can cause this same condition, > so both SLIPs should be set as follows: > > SLIP SET,COMP=878,A=SVCD,SDATA=(ALLNUC, > PSA,SQA,CSA,LPA,TRT,LSQA,RGN),END > > > SLIP SET,COMP=80A,A=SVCD,SDATA=(ALLNUC, > PSA,SQA,CSA,LPA,TRT,LSQA,RGN),END > > > > Also, depending on the reason code, do one of the following: > 10 > Try increasing the region size specified in the region parameter on the > JOB or EXEC statement in the JCL for the job. However, if the cause of the > problem is actually that a program is requesting virtual storage and not > freeing it, the abend will recur when the program uses the virtual storage > in the larger region. > > > > > Daniel McLaughlin > ZOS Systems Programmer > Crawford & Company > PH: 770 621 3256 > [EMAIL PROTECTED] > > If you aim at nothing you will hit it every time. > - Zig Ziglar ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
