Are you sure that it is on the volume and type that you specified? If it is SMS managed then you should use 'SMS' instead of UNIT and VOLSER.
Jon L. Veilleux [EMAIL PROTECTED] (860) 636-2683 -----Original Message----- From: IBM Mainframe Discussion List [mailto:[EMAIL PROTECTED] On Behalf Of Mark Yuhas Sent: Monday, March 12, 2007 11:49 AM To: [email protected] Subject: Re: Module search sequence question Response to Peter Relson's post: "I would guess that your steplib consists of multiple data sets" Nope. Only one library in the STEPLIB concatentation. "Then, assuming that "A" was linkedited with AC=3D1, "A" gets control APF-authorized, and cannot load from an unauthorized steplib and thus finds "B" in the (authorized) LNKLST rather than "B'" in the unauthorized steplib." No, again. I specifically authorized the STEPLIB data set with the 'SETPROG APF,ADD' command. Further, I even supplied UNIT & VOLSER for the STEPLIB data set. This is an anomaly that I can work around but it does go against what I have known about module search sequence. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html ----------------------------------------- This e-mail may contain confidential or privileged information. If you think you have received this e-mail in error, please advise the sender by reply e-mail and then delete this e-mail immediately. Thank you. Aetna ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
