Lizette, Many years ago there was a "Block character routine" available in library SYS1.AOSB0, named IEFSD095. This routine was (is?) used to create the block letters for JES2 separator pages. Documentation: The page I copied from an old manual says "Job Management - External Writers". I hope this gives you a starting point for further research.
Regards, Ulrich Krueger -----Original Message----- From: IBM Mainframe Discussion List [mailto:[EMAIL PROTECTED] On Behalf Of Lizette Koehler Sent: Tuesday, September 18, 2007 09:09 To: [email protected] Subject: Need a program to create BLOCK Letters I had one of these a long time ago written in assembler. I am looking for a pgm that will create a BLOCK of a LETTER For example, I pass it a T it would produce output like this (if it could slant it that would be very nice). TTTTTTTTT TTTTTTTTT TT TT TT TT Does anyone have anything like this? I have scaned the files in CBT Tape but the one liners do not tell if there is such a pgm. I did find a couple called BLOKHDR but it only created a phrase in a block, not a block letter. Thanks Lizette ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
