On Thu, 13 Mar 2008 21:54:31 -0400, Knutson, Sam wrote: >At the time change here an anomaly occurred in RMF. >I opened a PMR on this but we have only the WTO message which occurred on every system in the Sysplex when the ETR changed the time. > (snip) > >It would be useful if someone else also had this occur so Level-2 had more than a one customer population that asserts something is odd here. I don't like odd. The message should not come out if RC/RSN = 00 but it did so something is not correct. > >If you observe daylight savings time, run RMF Monitor III, and make the time change automatically using an ETR (or not) I would appreciate it if you could check and see if you had this happen and contact me. > >Thanks In Advance! > > Best Regards, > > Sam Knutson
We run seven LPARs where ETR automatically changed time at the start of Daylight Saving Time this year. On every RMFGAT task, the following messages appear: All msgs at exactly 03:00:00: ERB803I III: MONITOR III DATA SET SUPPORT TERMINATED ERB307I III: MONITOR III DATA GATHERER ERB3GINI. INTERFACE BPX1SDD ERB307I III: FAILED. RETURN CODE: 0000 REASON CODE: 0000 ERB105I III: DATA GATHERER ACTIVE I suspect ERB803I and ERB105I are the normal messages for time change, and that perhaps because of the interface used internally to "recycle" Monitor III, the ERB307I RC0 RSN0 may have been a side effect. By the way, we did not ourselves manually recycle RMF or RMFGAT at time change. These messages simply appear in the job log of the still running RMFGAT task which has been running since our last IPL in February. Brian ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
