Thanks John, That was it. I figured it was something simple. The correct setc was commented, so I reversed the two.
Eric ---- John P Kalinich <[EMAIL PROTECTED]> wrote: > Eric Bielefeld of the IBM Mainframe Discussion List <[email protected]> > wrote on 03/20/2008 12:53:13 PM: > > > I am trying to use the RELEASE command with PDS86. I've used it in > > the past to release extents, and release space from PDS's and leave > > a certain amount of free space. I keep getting an S0C4 abend at > > +X'364 into the module. This is the CBT version that comes in load > > module format in file 035. I then downloaded the source from file > > 296 and assembled it with the exact same results. > > > > Anyone have any ideas why this doesn't work? > > > > Did you assemble with the following SETC? I think it defaults to something > else. > > &MVSLEV SETC 'MVS220' > > Regards, > John K -- Eric Bielefeld Systems Programmer Aviva USA Des Moines, Iowa 515-645-5153 ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
