> -----Original Message-----
> From: IBM Mainframe Discussion List On Behalf Of Mark Zelden
>
> On Sun, 1 Jun 2008 14:10:08 -0400, Sam Golob
> <[EMAIL PROTECTED]> wrote:
>
> >Hi Folks,
> >
> > If you are a user of the LOOK TSO command to browse
> active storage,
> >from CBT Tape File 264 (www.cbttape.org - see Updates page),
> you have
> >to be informed of the following development:
> >
> >Important note, for the LOOK command to work:
> >--------- ---- --- --- ---- ------- -- ----
> > Note from Sam Golob: The LOOK program needs
> > a PARMLIB setting in the active DIAGxx member:
> > ****
> > >>>>>>>> VSM ALLOWUSERKEYCSA(YES) <<<<<<<<
> >
> > This was the default until z/OS 1.8, but in
> > z/OS 1.9, VSM ALLOWUSERKEYCSA(NO) is the
> > default. It now has to be specifically set to
> > VSM ALLOWUSERKEYCSA(YES), or LOOK will abend
> > with a SB0A, reason code 5C.
> >-------------------------------------------------
> >
> > This is one of the "gotchas" that get you when you go to
> a new z/OS
> >release. Better to be informed, than not informed. The
> solution was
> >discovered, when I looked up the SB0A, reason code 5C abend
> in the z/OS
> >1.9 System Codes book. Since a lot of people use the LOOK
> command (or
> >at least they SHOULD), I figured I'd spread the word around.
> >
> > All the best of everything to y'all........
> >
> >Sam
> >
>
> IMO, this should be APAR-able or there should be a documented
> work around. Did you open up a PMR with IBM or search IBMLINK?
Does IBM accept PMRs for CBTTAPE programs? :-)
-jc-
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
