IIRC, you can also specify (for JES2 at least) multiple DESTIDs for a printer, so you could just specify LOCAL in the list for one printer if you wanted all LOCAL output to go there.
Bill On Thu, 5 Mar 2009 14:43:29 -0500, Scott Rowe <[email protected]> wrote: >I think you can assign a DESTID to RMT0 (which is the same as LOCAL), and then tell the print software to use that DESTID. It's been a couple years since I looked at this though, so I could be off base. > >>>> Melissa Perry <[email protected]> 3/5/2009 1:39 PM >>> >We are getting rid of our channel attached printers. We will be using printers >that are defined to JES as DEST's. Is there any way to change the 'LOCAL' >output to go to a DESTID without coding /*route print cards in the JCL? > > > >CONFIDENTIALITY/EMAIL NOTICE: The material in this transmission contains confidential and privileged information intended only for the addressee. If you are not the intended recipient, please be advised that you have received this material in error and that any forwarding, copying, printing, distribution, use or disclosure of the material is strictly prohibited. If you have received this material in error, please (i) do not read it, (ii) reply to the sender that you received the message in error, and (iii) erase or destroy the material. Emails are not secure and can be intercepted, amended, lost or destroyed, or contain viruses. You are deemed to have accepted these risks if you communicate with us by email. Thank you. > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
