Mark,
Here's a subsection of my 1.7 TCPIP.PROFILE.TCPIP with your addresses plugged
into it. I am not using OMPROUTE and I would guess you don't need it either.
I am also assuming you have 1 OSA adapter that you're using for this.
DEVICE GIGADEV1 MPCIPA
LINK GIGA10 IPAQENET GIGADEV1
GLOBALCONFIG
NOSEGMENTATIONOFFLOAD
HOME
192.168.150.1 GIGA10
BEGINROUTES
ROUTE 192.168.150.0 255.255.255.0 = GIGA10 MTU 65535
ROUTE DEFAULT 192.168.150.254 GIGA10 MTU DEFAULTSIZE
ENDROUTES
Then in SYS1.VTAMLST you need a TRLNODE definition to map the TCP/IP
definitions to the channel addresses of the OSA card:
TRLGIGA VBUILD TYPE=TRL
********************************************************************
* GIGABIT ETHERNET TRANSPORT RESOURCE LIST MAJOR NODE
* THIS DEFINED THE ETHEREXPRESS CARD ON ADDRESSES FD00-FD02
* WITH OSAD AS DEVICE NUMBER FD0F, ADDRESS FDFE
********************************************************************
TRLFD00 TRLE LNCTL=MPC, X
READ=FD00, X
WRITE=FD01, X
DATAPATH=(FD02), X
PORTNAME=GIGADEV1, X
MPCLEVEL=QDIO
HTH
Rex
-----Original Message-----
From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of
Mark Wilson
Sent: Monday, June 08, 2009 4:39 PM
To: [email protected]
Subject: TCPIP config on z/OS 1.7 ADCD
Hi,
Ignoring the ³It¹s not supported² issues....
I have a problem with zOS 1.7 and TCPIP..
I need to re-build the image from a backup of our ADCD system on our z890 to
perform a set of tests for a customer.
I am having an issue configuring TCPIP and was looking for some words of
wisdom. Our IP setup has changed this we last used this system and need to
make some changes!
I need to configure the IP stack as follows:
HOME address of: 192.168.150.1
Default Gateway of: 192.168.150.254
Subnet mask of: 255.255.255.0
TCPIP starts fine and there are error messages.
My initial question is do I need to configure the OMPROUTE STC? This system
is for internal use only and the 192.168.150.1 IP address is a valid address
on our network.
I have configure the OSA ICC side of the OSA and that works fine.
Subsequent questions are what would you expect to specify for the GATEWAY &
DEFAULTNET statements...
As you can probably guess TCPIP is not one of my strong subjects....
Any other hints or tips would be gratefully appreciated..
Regards
Mark
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
