These steps should allow you to install your JES3 Exit make any subsequent
changes:
1. Copy the load module to SYS1.SIATLIB ( or other library that is the
first library in the LINKLIST)
2. F LLA,REFRESH
3. *MODIFY,X,M=IATUX45,REFRESH
A JES3 Restart is not required. You will also need to update your JES3 PARMS
to make the change permanent.
Mike Kean
Developer Direct Services
Xerox Corporation
407 862-2684 (w)
407 468-8443 (c)
[email protected]
-----Original Message-----
From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf
Of Donald J.
Sent: Tuesday, October 02, 2012 8:44 AM
To: [email protected]
Subject: Basic JES3 Exit Question
I am new to JES3, and have a JES3 exit 45 to install/update for XPAF.
After wading thru the manuals, they only say to copy to SYS1.SIATLIB.
Is anything else required (other than LLA refresh)? Is a JES3 restart required?
--
http://www.fastmail.fm - A fast, anti-spam email service.
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions, send email to
[email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
