Thanks a lot Steve, it is most helpful Arye. On Thu, May 27, 2021 at 3:53 AM [email protected] <[email protected]> wrote:
> Arye: > > I think I can answer Q1. > > Yes, you can define in the Netmap the Primary address/nodename to connect > with, and then alternate addresses or node names. However, if one is using > LU0, and checkpoint restart, one can only do LU0 connections. But if LU0 > did not get used, then any alternate that is not LU0 can be used. > > I have a hazy memory of the process language having been enhanced to allow > a process to use alternates. > > Back to LU0: > > In other words, don't mix LU0 with NON-LU0 connections in your NETMAP or > process (assuming LU0 is still supported). > > LU0 is one of the oldest SNA protocols for C:D and it does not have the > "enhanced" checkpoint records. The other protocols do. > > Oh, there was one more protocol being worked on in 2012, and I do not know > what its name would be or if it even made it to GA. > > Q2: I don't think this is supported. Now I know there was some interface > for LRS. But I only did a few tests of it in the automated regression > tester, so I don't remember much about it. > > In fact, all this stuff that was burned in my brain from working on C:D is > kind of fading. > > Regards, > Steve Thompson > > > --- [email protected] wrote: > > From: Arye Shemer <[email protected]> > To: [email protected] > Subject: [IBM-MAIN] Connect:direct questions > Date: Wed, 26 May 2021 21:53:27 +0300 > > Hello, > Couple of questions regarding Connect:Direct. > > Q1: Is Connect:direct recovery procedures able to use alternate targets > when transmission to primary target failed ? > Q2: Is Connect:direct able to use Subsystem Interface to intercept JOB > output written to DD card (like Alebra) ? > > I read Connect:direct knowledgcenter but could not find a clear answer to > my questions. > Thanks for any help or pointer to where i can find answers, > Arye Shemer, > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
