I could also reword it to be 'I cannot configure it to meet the unknown
standards of the check'
The SDSF display of the check does not include any internal buffers used inside
the check.
It says 'something' isn't right, and 'here are the commands that can fix it',
They key phrase in the display is 'not reasonable'.
What IS reasonable??
As a poor uninformed user, I do not know how to feed the console modification
commands OR configure z/OSMF to get these two things to play nice.
For all I know, the health checker 'valid' will cause z/OSMF to have reduced
functionality.
What i do know is that the 'defaults' from z/OSMF is triggering the health
check.
---
CNZHF0003I One or more consoles are configured with a combination of
message scope and routing code values that are not reasonable.
Explanation: Report message CNZHR0003I identifies consoles that have
been configured to have a multi-system message scope and either all
routing codes or all routing codes except routing code 11.
Note: For MCS, SMCS and HMCS consoles, only the consoles which are
defined on this system are checked. All EMCS consoles are checked.
System Action: The system continues processing.
Operator Response: N/A
System Programmer Response: To view the attributes of all consoles,
issue the following commands:
DISPLAY CONSOLES,L,FULL
DISPLAY EMCS,FULL,STATUS=L
Update the MSCOPE or ROUTCODE parameters of MCS, SMCS and HMCS
consoles on the CONSOLE statement in the CONSOLxx parmlib member
before the next IPL. For EMCS consoles (or to have the updates to
MCS/SMCS/HMCS consoles in effect immediately), you may update the
message scope and routing code parameters by issuing the VARY CN
system command with either the MSCOPE, DMSCOPE, ROUT or DROUT
parameters. Note: The VARY CN system command can only be used to set
the attributes of an active console. If an EMCS console is not
active, find out which product activated it and contact the product
owner. Effective with z/OS V2R1, you can use the SETCON DELETE
system command or the EMCS console removal service (IEARELEC in
SYS1.SAMPLIB) to remove any EMCS console definition that is no
longer needed.
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
