Make sure that when you start your IPCS session that there is not already another system dump in IPCS's dump directory that it is browsing by default. You should list all the dump data sets in the dump directory and also check the data set name that IPCS is using as its current default. I always look in the directory and delete all dumps in there, if any, before I start browsing a new dump data set. I also try to remember to delete the dump data set that I browsed from the directory when I have finished browsing it, but I don't always remember, which is why I always display the directory before doing anything else after starting IPCS.
Bill Fairchild Franklin, TN “Political language is designed to make lies sound truthful and murder acceptable, and to give the appearance of solidity to pure wind.” [George Orwell] ----- Original Message ----- From: "Scott Ford" <[email protected]> To: [email protected] Sent: Tuesday, May 28, 2013 10:46:00 AM Subject: Re: ECSA Shmuel: yes sir it was, there is data in 'sys1.trace' what I see is IPCS - subcommand GTFTRACE not recognizing or formatting if that's wthe workd you want to use the data ...its doesn't see the usr(F65) and I think that is odd. I went right out of the MVS diag manual .... Scott J Ford Software Engineer http://www.identityforge.com/ ________________________________ From: Shmuel Metz (Seymour J.) <[email protected]> To: [email protected] Sent: Tuesday, May 28, 2013 10:46 AM Subject: Re: ECSA In <[email protected]>, on 05/27/2013 at 04:55 PM, Scott Ford <[email protected]> said: >//IEFRDER DD >DSNAME=SYS1.TRACE,UNIT=SYSDA,SPACE=(CYL,20), 00150001 >// DISP=(NEW,KEEP) Try DISP=(,CATLG) >10. I try IPCS with GTFTRACE da('sys1.trace') usr(f65) > IPCS - gtf says no use able data for USR=SEL ... Was IPCS looking at the same SYS1.TRACE? -- Shmuel (Seymour J.) Metz, SysProg and JOAT Atid/2 <http://patriot.net/~shmuel> We don't care. We don't have to care, we're Congress. (S877: The Shut up and Eat Your spam act of 2003) ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
