Test works fine for me debugging was just wondering if tool worked as a backup
On Wed, Dec 10, 2025 at 10:36 AM Dave Day <[email protected]> wrote: > You might try using SLIP with instruction fetch. I know it writes to the > trace table, but I believe you can also have it write to a GTF dataset. > Haven't looked at the doc in quite a while. I don't think having SLIP > instruction fetch looking at code running in an estae will make any > difference to SLIP, but have never tried it. > > If you are using TSO TEST, set a breakpoint at some point where you can > get the address of the estae routine. > > Issue the SLIP command, start GTF, then run the code. > > Stop the SLIP. Stop GTF. > > If you are not using GTF, get a dump, format the trace table. > > If you are using the trace table, you probably want to make sure the > size of the table is sufficient. If there is a lot of other activity in > the same machine that you are using to test your code, GTF is a better > option. > > Hope this helps. > > -- Dave Day > > On 12/10/2025 7:40 AM, Joseph Reichman wrote: > > I am writting an Estae recovery at work ( not my Zpdt system ) > > > > I am debugging with TSO TEST ( they don’t have XDC ) here > > > > The recovery pgm is in a separate load module > > > > Would like to have a backup debugger would anyone know if you can use > debug tool for this > > > > Thanks > > ---------------------------------------------------------------------- > > For IBM-MAIN subscribe / signoff / archive access instructions, > > send email to [email protected] with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
