If not LE then the requirement is to not have ESPIE active as that interferes with Debug Tool. If your ESTAE is in a separate module, then it must be loaded in memory and you set the breakpoint manually. If necessary you can use the LOAD command in DT.
On Thu, Jul 9, 2026 at 10:18 AM Joseph Reichman < [email protected]> wrote: > It’s not a LE program and your secon state ment indicates it cannt be a > separate load module > > > Joe Reichman > > On Wed, Jul 8, 2026 at 8:16 PM Attila Fogarasi < > [email protected]> wrote: > > > you must use LE options of TRAP(ON,NOSPIE) and set a manual breakpoint at > > entry of your ESTAE routine, which lets you manually step through your > > ESTAE logic. > > > > On Thu, Jul 9, 2026 at 10:01 AM Joseph Reichman < > > [email protected]> wrote: > > > > > Can you do LDD recover > > > And the. At entry recover > > > > > > Or is it more complicate > > > > > > If someone can show me the setup would appreciate it > > > > > > ---------------------------------------------------------------------- > > > For IBM-MAIN subscribe / signoff / archive access instructions, > > > send email to [email protected] with the message: INFO IBM-MAIN > > > > > > > ---------------------------------------------------------------------- > > For IBM-MAIN subscribe / signoff / archive access instructions, > > send email to [email protected] with the message: INFO IBM-MAIN > > > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
