Okay, I am feeling little dense this morning/week. I am trying to decode how to determine the best value to set for MAXMSG. Having read and re-read applicable sections of "Setting Up A Sysplex", I am still not "getting it".
Reason for being there? From the SR: EZZ4338I ERROR REPORTED ON INTERFACE EZ6XCFID - CODE 80100044 DIAGNOSTIC CODE 03 EZZ4310I ERROR: CODE=80100044 REPORTED ON DEVICE VTAMF. DIAGNOSTIC CODE: 03 EZZ4337I ATTEMPTING TO RECOVER INTERFACE EZ6XCFID EZZ4309I ATTEMPTING TO RECOVER DEVICE VTAMF IST1504I XCF CONNECTION WITH WDPC.VTAMF IS INOPERATIVE 664 IST1501I XCF TOKEN = 0300013600270003 IST1578I DEVICE INOP DETECTED FOR ISTTCDID BY ISTTSCBX CODE = 001 IST314I END IST1578I SOFT INOP DETECTED FOR ISTTCDID BY ISTTSC8X CODE = 005 . These messages indicate an XCF buffer shortage as described in Technote SWG21244665 which reads as follows: For ISTXCF, the MAXMSG parameter for PATHIN and PATHOUT should be tuned to its upper limit value. The higher value of MAXMSG parameter does not cause XCF to use more storage. Therefore, you can raise the value of your MAXMSG parameter to resolve this problem. Any advice on how to decode the manual and come up with a "happy value" would be appreciated. Which maxmsg? Bob ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
