Hello All, Cross posted to IBM MAIN and JES2 listserves
I submitted a job with a route card /*ROUTE LPAR99 from the LPAR77(Both the LPARS are MVA guest running on Z/VM), But the Job stays in XMITTER status and the Job is not executing on the target LPAR(LPAR99) NETSRV1 is active on both the LPAR(LPAR99 and LPAR77). Z/OS : 1.13 Could someone point me to the right direction. On Wed, Sep 18, 2013 at 10:45 AM, mf db <[email protected]> wrote: > Hello, > > Yes, the two MVS guest are coupled with CTC's > > > > > On Wed, Sep 18, 2013 at 2:49 AM, Tom Wasik <[email protected]> wrote: > >> It would seem to me that using TCP/IP would be the easiest way to make >> this NJE connection happen (again as long as they are not in the same MAS). >> Assuming each MVS image has an IP address that can be accessed from the >> other MVS image, then it is just a matter of defining the needed NJE >> NETSERVs, SOCKETs, and LINEs in JES2. >> If you do not have TCP/IP for some reason, and you are 2 guests on the >> same VM image, you can use virtual CTC adapters in VM to set up a BSC >> connection between the 2 guest images. This is a bit old fashion, but it >> still works and is probably the easiest NJE to set up (assuming you >> understand the VM commands to couple the virtual CTCs). >> You can look in the JES2 initialization and tuning guide for more >> information or there is a SHARE presentation that could help: >> >> https://share.confex.com/share/119/webprogram/Handout/Session11757/What%20are%20all%20these%20JES2%20NJE%20Options.pdf >> >> Tom Wasik >> JES2 Development >> > > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
