Howdy, Without knowing your system configuration, I would like to add my suggestions.
1) Have you issued the command from an HMC console? 2) Have you tried the command from the support element? 3) Issue the command from a batch job to see if you can trap an error message. Regards, Neil Haley [email protected] Storage & Software Mainframe Support http://www.ibm.com/systems/z/ | http://www.about.me/NeilHaley From: John Norgauer <[email protected]> To: [email protected], Date: 11/12/2013 14:37 Subject: D T command gives no result. Sent by: IBM Mainframe Discussion List <[email protected]> After a long weekend with NO system changes(that I know of) when I issue "D T", nothing else appears on the console. Any thoughts please. John Norgauer Senior Systems Programmer Mainframe Technical Support Services University of California Davis Medical Center 1651 Alhambra Blvd Suite 200 Sacramento, Ca 95816 916-734-0536 SYSTEMS PROGRAMMING...... Guilty, until proven innocent !! " JN 2004 ........ "Hardware eventually breaks - Software eventually works" anon ........ ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
