Hi Jimmy,
As Skip said, the JES2PARMS may indeed be the same. There are many values in JES2 that can be dynamically modified by command. I recommend the fine JES2 Reference manual. For a start, try the following command in the LPARS that work as expected and the ones that don't. Note any differences in the display command responses and check those out. I would also recommend that you not make any changes until finding out why things are different. This will display the settings for jobclass a. $djobclass(a),long HTH, Linda ----- Original Message ----- From: "Jimmy Pace" <[email protected]> To: [email protected] Sent: Thursday, February 27, 2014 10:19:44 AM Subject: JES2 Job Listings z/OS 1.13 A job is run on this LPAR and uses a MSGCLASS other than one set in JESPARMS that is (HOLD,HOLD), the sysprint and the JESJCL, JESYSMSG, and JESMSGLG are separated. If the msgclass is (WRITE,WRITE) then the sysprint goes to the output queue and the JES* goes to the held queue with a HOLD ODISP. With a MSGCLASS (HOLD,HOLD) : everything goes to held queue. Job is a IDCAMS listcat with one step and one sysprint. There are 4 LPARs (all are z/OS 1,13), 2 of them have this problem and 2 do not. When this same job is run on an LPAR that is not having this problem using a MSGCLASS with (WRITE,WRITE), all the output goes to the OUTPUT queue. The JESPARMS have been compared between the LPARs and MSTJCL to see if there were differences, nothing obvious. The only JES2 exit running is EXIT0 which I think, comes as a default. The only SMF exits customized are IEFU29 and IEFACTRT. The LPAR with the problem doesn't have any product like $avrs active, also, it doesn't appear any messages are being suppressed from the syslog. Thanks in advance for any insight. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
