Rob I have question I understand that an authorized command run under a different tmp
Is that always meaning the same program while in problem state runs Under one tmp and when I switch to Supervisor under another If so I established my estae(x) In Problems state and I abended in supervisor state my recovery rtn wouldn't get control ? Sent from my iPhone > On Aug 27, 2014, at 7:07 AM, Micheal Butz <[email protected]> wrote: > > Thanks > Sent from my iPhone > >> On Aug 27, 2014, at 5:50 AM, Rob Scott <[email protected]> wrote: >> >> Hint : parallel TMP >> >> Rob Scott >> Lead Developer >> Rocket Software >> 77 Fourth Avenue . Suite 100 . Waltham . MA 02451-1468 . USA >> Tel: +1.781.684.2305 >> Email: [email protected] >> Web: www.rocketsoftware.com >> >> >> -----Original Message----- >> From: IBM Mainframe Discussion List [mailto:[email protected]] On >> Behalf Of Micheal Butz >> Sent: 27 August 2014 10:47 >> To: [email protected] >> Subject: Re: Recovery routines >> >> It is declared as authorized in IKJTSOxx what is the significance of that >> I'll research it thanks >> >> Sent from my iPhone >> >>> On Aug 27, 2014, at 5:25 AM, Rob Scott <[email protected]> wrote: >>> >>> This is where you need to do some elimination of certain factors : >>> >>> (1) Does your ESTAE actually work? >>> Test it by doing a link to a dummy program and forcing that dummy >>> program to abend >>> >>> (2) Is it related to the TSO command environment? >>> Test this by using "TSO dummy" and re-test using the dummy program >>> from (1) >>> >>> (3) Is there something special about the TSO command processor? >>> For example, is it declared in AUTHxxx in IKJTSOxx ? (If so - this >>> explains your problem) >>> >>> (4) Is it related to ISPF services >>> Add some ISPF services to your dummy program and re-test >>> >>> >>> >>> Rob Scott >>> Lead Developer >>> Rocket Software >>> 77 Fourth Avenue . Suite 100 . Waltham . MA 02451-1468 . USA >>> Tel: +1.781.684.2305 >>> Email: [email protected] >>> Web: www.rocketsoftware.com >>> >>> >>> -----Original Message----- >>> From: IBM Mainframe Discussion List [mailto:[email protected]] >>> On Behalf Of Micheal Butz >>> Sent: 27 August 2014 00:54 >>> To: [email protected] >>> Subject: Re: Recovery routines >>> >>> It was a TSO command processor >>> Which I execute from within >>> ISPF With following syntax >>> TSO CMDPGM >>> >>> >>> >>> Sent from my iPhone >>> >>>>> On Aug 26, 2014, at 7:39 PM, Walt Farrell <[email protected]> wrote: >>>>> >>>>> On Tue, 26 Aug 2014 18:02:01 -0400, Micheal Butz >>>>> <[email protected]> wrote: >>>>> >>>>> It hasn't retried >>>>> >>>>> I establish an estaex in the begining Of My program then load >>>>> another program The second program gets a S0C4 I get an ISP message >>>>> re a S0C4 and the program ends my routine Never has a chance to >>>>> examine It point is if everything is still und > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
