Yes. But the issue is.. if I set boundary to TARGET zone then all dataset under target zone ( target and distribution ) both volume will be changed, which I dont want. I want to change only for Target dataset.
On Wed, Sep 3, 2014 at 3:02 PM, Andy Taylor <[email protected]> wrote: > Ok, I believe I understand. In which case, are the DDDEFs for the target > libraries the only DDDEFs in your target zone with VOLUME pointing at your > sysres? If so can't you use ZONEEDIT with a conditional? (SMP/E Commands > Manual has an example). > > Regards > > Andy T. > > > On 3 Sep 2014, at 10:21, Mainframe Mainframe <[email protected]> > wrote: > > > Thanks for reply. But I am not looking for single DDDEF entry. I want to > > update all target dataset DDDEF using single JCL. I don't want to do it > > manually. As this will consume lots of time. > > > > > > On Wed, Sep 3, 2014 at 2:42 PM, Andy Taylor <[email protected]> > > wrote: > > > >> Hello > >> > >> Not quite sure why you think you can't update a single DDDEF entry, but > is > >> it because you're looking at the ZONEEDIT command as opposed to the > UCLIN > >> command? UCLIN will allow you to update a single DDDEF entry. > >> > >> Regards > >> > >> Andy T. > >> > >> > >> On 3 Sep 2014, at 09:36, Mainframe Mainframe <[email protected]> > >> wrote: > >> > >>> We have two copies of RES volume. Primary and Secondary in our z/OS > 1.13 > >>> systems.While setting up SMPE initially, we always make sure that SMPE > >>> DDDEF of target dataset should point to only Alternate RES volume and > we > >>> always run system with primary RES volume. > >>> > >>> So, while applying Maintenance new data will go into Alternate RES > >> volume, > >>> and running system will not be affected. > >>> > >>> But, I just saw that in one of our system, Target dataset DDDEF is not > >>> pointing to Alternate RES volume. But as we have indirectly catalogging > >>> setup, So, target zone DDDEF pointing that RES volume using that > system > >>> is IPL'd currently. > >>> > >>> But Now I have requirement of changing Target zone DDDEF to point to > Alt > >>> RES volume permanently . But my difficultly is, if I use CHANGE VOLUME > by > >>> setting up BDY as target zone then it will change all target and > >>> distribution dataset present in target zone which I dont want. Is there > >> any > >>> procedure, to change only Target dataset volume and UNIT parameter in > >>> target zone. > >>> > >>> ---------------------------------------------------------------------- > >>> For IBM-MAIN subscribe / signoff / archive access instructions, > >>> send email to [email protected] with the message: INFO IBM-MAIN > >> > >> ---------------------------------------------------------------------- > >> For IBM-MAIN subscribe / signoff / archive access instructions, > >> send email to [email protected] with the message: INFO IBM-MAIN > >> > > > > ---------------------------------------------------------------------- > > For IBM-MAIN subscribe / signoff / archive access instructions, > > send email to [email protected] with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
