Mark, On a zEC12, I have defined a group capacity set containing all lpars that enforces the max 4HRA limit to a value somewhat less. This was done for software billing purposes. I have also hard-capped several unruly lpars at much less than that group capacity MSU value. Not sure if this is supported on a z10, but why not try it on a maintenance window?
Bob -----Original Message----- From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of Martin Packer Sent: Tuesday, February 10, 2015 10:45 AM To: [email protected] Subject: Re: z10 BC LPAR Capping question Not sure. But would a Defined Capacity limit for the LPAR work instead? (Or better?) That certainly can be done - and I've seen it occasionally in my customer set. Cheers, Martin Martin Packer, zChampion, Principal Systems Investigator, Worldwide Banking Center of Excellence, IBM +44-7802-245-584 email: [email protected] Twitter / Facebook IDs: MartinPacker Blog: https://www.ibm.com/developerworks/mydeveloperworks/blogs/MartinPacker From: Mark Jacobs - Listserv <[email protected]> To: [email protected] Date: 10/02/2015 15:38 Subject: z10 BC LPAR Capping question Sent by: IBM Mainframe Discussion List <[email protected]> This isn't my area of expertise, but I've been asked if we can define a capacity defined group and also have one of the members of the group have a hard cap enabled. This is on a z10 BC processor. -- Mark Jacobs Time Customer Service Technology and Product Engineering The standard you walk past, is the standard you accept. Lieutenant General David Morrison ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN Unless stated otherwise above: IBM United Kingdom Limited - Registered in England and Wales with number 741598. Registered office: PO Box 41, North Harbour, Portsmouth, Hampshire PO6 3AU ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
